B1205 Volkswagen Gx3 OBD Code

OBD/2 B1205 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

B1205 Volkswagen Gx3 Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine B1205 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If b1205 eic switch-1 assembly circuit failure so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the b1205 eic switch-1 assembly circuit failure.

Common Causes of Volkswagen Gx3 B1205 OBD2 Code

A common cause of code B1205 is the failure of B1205 EIC Switch-1 Assembly Circuit Failure, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty TCM or TCM programming
Faulty select solenoid
Open or short in the CMP sensor circuits

B1205 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B1205 Volkswagen Gx3 OBD Code

B1205 Volkswagen Gx3 Error Code Repair Process :

Common Causes of Volkswagen Gx3 B1205 OBD2 Code

B1205 code for other Volkswagen cars