B1241 Suzuki Sx4 S-cross OBD Code

OBD/2 B1241 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

B1241 Suzuki Sx4 S-cross Error Code Repair Process :

The rule of B1241 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of b1241 wiper washer rear pump relay circuit short to battery. Likewise, overriding the OBD B1241 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Suzuki Sx4 S-cross B1241 OBD2 Code

A common cause of code B1241 is the failure of B1241 Wiper Washer Rear Pump Relay Circuit Short to Battery, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Damaged camshaft position (CMP) sensor
Incorrect fuel filler cap used
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

B1241 is a kind of Body Trouble Code

Auto body problems aren't always easy to spot. Diagnosing auto body problems sometimes requires a little know-how. In this section you'll find articles dedicated to teaching you how to diagnose auto body problems.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

B1241 Suzuki Sx4 S-cross OBD Code

B1241 Suzuki Sx4 S-cross Error Code Repair Process :

Common Causes of Suzuki Sx4 S-cross B1241 OBD2 Code

B1241 code for other Suzuki cars