C0128 Innocenti Mini OBD Code

OBD/2 C0128 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

C0128 Innocenti Mini Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C0128 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If wiper rear mode select switch circuit failure so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the wiper rear mode select switch circuit failure.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 30-110

Common Causes of Innocenti Mini C0128 OBD2 Code

A common cause of code C0128 is the failure of Wiper Rear Mode Select Switch Circuit Failure, but there are several other possible causes as well, such as ;

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Damaged ECM
• Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
• Open or short in the CMP sensor circuits

C0128 is a kind of Chassis Trouble Code Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C0128 code for other Innocenti cars

You can view according C0128 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• C0128 Innocenti 1100
• C0128 Innocenti 186
• C0128 Innocenti 650
• C0128 Innocenti 950
• C0128 Innocenti 990
• C0128 Innocenti A40
• C0128 Innocenti C
• C0128 Innocenti Elba
• C0128 Innocenti Im3
• C0128 Innocenti J4
• C0128 Innocenti Koral
• C0128 Innocenti Mille
• C0128 Innocenti Small
• C0128 Innocenti Turbo

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved