C0916 Rover P2 OBD Code

OBD/2 C0916 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like C0916 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

C0916 Rover P2 Error Code Repair Process :

If your prndl switch circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C0916 and engine control unit are in charge of monitoring a bunch of different prndl switch circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Rover P2 C0916 OBD2 Code

A common cause of code C0916 is the failure of PRNDL Switch Circuit Failure, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Faulty Crankshaft Position Sensor (POS)
Faulty Variable Camshaft Timing (VCT) position solenoid
Faulty ignition coil (s)

C0916 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C0916 Rover P2 OBD Code

C0916 Rover P2 Error Code Repair Process :

Common Causes of Rover P2 C0916 OBD2 Code

C0916 code for other Rover cars