C1189 Daihatsu Trevis OBD Code

OBD/2 C1189 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

C1189 Daihatsu Trevis Error Code Repair Process :

If your vehicle failed a C1189 test and the C1189 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses c1189 brake fluid level sensor input short circuit to ground a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look c1189 brake fluid level sensor input short circuit to ground: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Common Causes of Daihatsu Trevis C1189 OBD2 Code

A common cause of code C1189 is the failure of C1189 Brake Fluid Level Sensor Input Short Circuit To Ground, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
1Camshaft Position Sensor circuit poor electrical connection
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty Variable Camshaft Timing (VCT) position solenoid

C1189 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C1189 Daihatsu Trevis OBD Code

C1189 Daihatsu Trevis Error Code Repair Process :

Common Causes of Daihatsu Trevis C1189 OBD2 Code

C1189 code for other Daihatsu cars