C1672 Mazda Rx-4 OBD Code

OBD/2 C1672 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C1672 Mazda Rx-4 Error Code Repair Process :

If your o2 sensor circuit malfunction (bank 1 sensor 1) check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C1672 and engine control unit are in charge of monitoring a bunch of different o2 sensor circuit malfunction (bank 1 sensor 1), and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mazda Rx-4 C1672 OBD2 Code

A common cause of code C1672 is the failure of O2 Sensor Circuit Malfunction (Bank 1 Sensor 1), but there are several other possible causes as well, such as ;

Damaged VCT phaser
Clogged or faulty fuel injector (s)
Damaged VCT phaser
Radio frequency interference (RFI)

C1672 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C1672 Mazda Rx-4 OBD Code

C1672 Mazda Rx-4 Error Code Repair Process :

Common Causes of Mazda Rx-4 C1672 OBD2 Code

C1672 code for other Mazda cars