C2311 Mitsubishi Concept OBD Code

OBD/2 C2311 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

C2311 Mitsubishi Concept Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2311 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If vehicle speed sensor out of self test range so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the vehicle speed sensor out of self test range.

Common Causes of Mitsubishi Concept C2311 OBD2 Code

A common cause of code C2311 is the failure of Vehicle Speed Sensor Out Of Self Test Range, but there are several other possible causes as well, such as ;

Exhaust tube
Faulty Variable Camshaft Timing (VCT) position solenoid
Fuel Injectors circuit poor electrical connection
Lack of fuel

C2311 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C2311 Mitsubishi Concept OBD Code

C2311 Mitsubishi Concept Error Code Repair Process :

Common Causes of Mitsubishi Concept C2311 OBD2 Code

C2311 code for other Mitsubishi cars