C2951 Chevrolet Grand Blazer OBD Code

OBD/2 C2951 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

C2951 Chevrolet Grand Blazer Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine C2951 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If pats transceiver module signal is not received so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the pats transceiver module signal is not received.

Difficulty Level (Expert)
Level
Repair Time (60 Min.)
Time
Cost Prediction : $ 75-90

Common Causes of Chevrolet Grand Blazer C2951 OBD2 Code

A common cause of code C2951 is the failure of PATS Transceiver Module Signal Is Not Received, but there are several other possible causes as well, such as ;
Wrench Tool C2951 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C2951 code for other Chevrolet cars

You can view according C2951 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved