C2959 Mitsubishi Lancer Evo 10 OBD Code

OBD/2 C2959 error code description and symptoms.

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting. You will want to test the fuses with circuits loaded. Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.

C2959 Mitsubishi Lancer Evo 10 Error Code Repair Process :

If your autolamp delay circuit failure check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2959 and engine control unit are in charge of monitoring a bunch of different autolamp delay circuit failure, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mitsubishi Lancer Evo 10 C2959 OBD2 Code

A common cause of code C2959 is the failure of Autolamp Delay Circuit Failure, but there are several other possible causes as well, such as ;

EVAP canister or fuel tank leaks
Faulty Fuel injector
Faulty Mass Air Flow (MAF) sensor
Faulty starter motor

C2959 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

C2959 Mitsubishi Lancer Evo 10 OBD Code

C2959 Mitsubishi Lancer Evo 10 Error Code Repair Process :

Common Causes of Mitsubishi Lancer Evo 10 C2959 OBD2 Code

C2959 code for other Mitsubishi cars