C3304 Isuzu Unicab OBD Code

OBD/2 C3304 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

C3304 Isuzu Unicab Error Code Repair Process :

The rule of C3304 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of interior scanning sensor circuit failure. Likewise, overriding the OBD C3304 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Isuzu Unicab C3304 OBD2 Code

A common cause of code C3304 is the failure of Interior Scanning Sensor Circuit Failure, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Engine Control Module (ECM)
Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
Open circuits caused by damage to wiring.

C3304 is a kind of Chassis Trouble Code

Diagnosing chassis noises can be one of the most frustrating problems technicians face. Fortunately, manufacturers have engineered noise, vibration and harshness (NVH) diagnostic techniques and equipment to find the source of the noise.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

C3304 Isuzu Unicab OBD Code

C3304 Isuzu Unicab Error Code Repair Process :

Common Causes of Isuzu Unicab C3304 OBD2 Code

C3304 code for other Isuzu cars