Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM). If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.
At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.
When you turn on the ignition, the Service Engine Soon or Check Engine P016D light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If engine overtemp condition so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the engine overtemp condition.
Difficulty Level (Easy)
|
Repair Time (20 Min.)
|
| Cost Prediction : $ 30-110 |
|
P016D is a kind of Powertrain Trouble Code
Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air. |
You can view according P016D DTC for your car model. We selected several models to see obd2 solutions click and view it.
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved