P0208 Hyundai Elantra OBD Code

OBD/2 P0208 error code description and symptoms.

The Transmission Range Sensor (also referred to as the PRNDL input an/or neutral safety switch) tells the transmission control module (TCM) an the engine control module (PCM) that the transmission is in park, reverse, neutral, drive, low, 2nd, 3rd etc. It is attached directly to the manual valve of transmission, so when the shift lever is moved from park to drive, the Transmission Range Sensor communicates this critical information to the above mentioned vehicle control module systems.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

P0208 Hyundai Elantra Error Code Repair Process :

If your p0208 injector circuit malfunction cylinder 8 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P0208 and engine control unit are in charge of monitoring a bunch of different p0208 injector circuit malfunction cylinder 8, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Hyundai Elantra P0208 OBD2 Code

A common cause of code P0208 is the failure of P0208 Injector Circuit Malfunction Cylinder 8, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Engine Control Module (ECM)
Fuel filler cap remains open or fails to close
Variable Valve Timing (VVT) circuit is open or shorted

P0208 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P0208 Hyundai Elantra OBD Code

P0208 Hyundai Elantra Error Code Repair Process :

Common Causes of Hyundai Elantra P0208 OBD2 Code

P0208 code for other Hyundai cars