P02AA Bristol Brigand OBD Code

OBD/2 P02AA error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Circuit High Input codes like P02AA are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

P02AA Bristol Brigand Error Code Repair Process :

If your vehicle failed a P02AA test and the P02AA Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses purge flow sensor circuit malfunction a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look purge flow sensor circuit malfunction: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Easy)

Repair Time (45 Min.)

Cost Prediction : $ 70-220

Common Causes of Bristol Brigand P02AA OBD2 Code

A common cause of code P02AA is the failure of Purge Flow Sensor Circuit Malfunction, but there are several other possible causes as well, such as ;

• Camshaft Position Sensor harness is open or shorted
• 1Camshaft Position Sensor circuit poor electrical connection
• Faulty spark plug (s)
• Oil Control Valve (OCV) circuit is open or shorted

P02AA is a kind of Powertrain Trouble Code Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P02AA code for other Bristol cars

You can view according P02AA DTC for your car model. We selected several models to see obd2 solutions click and view it.

• P02AA Briscoe Cloverleaf
• P02AA Bristol 400
• P02AA Bristol 401
• P02AA Bristol 402
• P02AA Bristol 403
• P02AA Bristol 404
• P02AA Bristol 405
• P02AA Bristol 406
• P02AA Bristol 407
• P02AA Bristol 408
• P02AA Bristol 409
• P02AA Bristol 410
• P02AA Bristol 411
• P02AA Bristol 412
• P02AA Bristol 450
• P02AA Bristol 603
• P02AA Bristol Beaufighter
• P02AA Bristol Blenheim
• P02AA Bristol Britannia
• P02AA Bristol Fighter

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved