P06D4 Isuzu Amigo OBD Code

OBD/2 P06D4 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code P06D4, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code P06D4 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

P06D4 Isuzu Amigo Error Code Repair Process :

If your vehicle failed a P06D4 test and the P06D4 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses fuel tank pressure sensor circuit open a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look fuel tank pressure sensor circuit open: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Difficulty Level (Soso)
Level
Repair Time (50 Min.)
Time
Cost Prediction : $ 20-50

Common Causes of Isuzu Amigo P06D4 OBD2 Code

A common cause of code P06D4 is the failure of Fuel Tank Pressure Sensor Circuit Open, but there are several other possible causes as well, such as ;
Wrench Tool P06D4 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P06D4 code for other Isuzu cars

You can view according P06D4 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved