P1948 Skoda Winnetou OBD Code

OBD/2 P1948 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

P1948 Skoda Winnetou Error Code Repair Process :

The rule of P1948 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of camshaft position sensor circuit intermittent. Likewise, overriding the OBD P1948 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Skoda Winnetou P1948 OBD2 Code

A common cause of code P1948 is the failure of Camshaft Position Sensor Circuit Intermittent, but there are several other possible causes as well, such as ;

Exhaust tube
EVAP system hose leaking
Fuel injectors harness is open or shorted
Oil flow restriction in the oil passages or the variable camshaft timing (VCT) valve body

P1948 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P1948 Skoda Winnetou OBD Code

P1948 Skoda Winnetou Error Code Repair Process :

Common Causes of Skoda Winnetou P1948 OBD2 Code

P1948 code for other Skoda cars