P2010 Isuzu Gemini OBD Code

OBD/2 P2010 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC P2010 as an indication of a hard fault.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

P2010 Isuzu Gemini Error Code Repair Process :

If your p2010 intake manifold runner control circuit high bank 1 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P2010 and engine control unit are in charge of monitoring a bunch of different p2010 intake manifold runner control circuit high bank 1, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Isuzu Gemini P2010 OBD2 Code

A common cause of code P2010 is the failure of P2010 Intake Manifold Runner Control Circuit High Bank 1, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
1Camshaft Position Sensor circuit poor electrical connection
Clogged or faulty fuel injector (s)
Faulty TCM or TCM programming

P2010 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P2010 Isuzu Gemini OBD Code

P2010 Isuzu Gemini Error Code Repair Process :

Common Causes of Isuzu Gemini P2010 OBD2 Code

P2010 code for other Isuzu cars