P3139 Chrysler 300 OBD Code

OBD/2 P3139 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P3139 Chrysler 300 Error Code Repair Process :

If your seat rear vertical motor position out of range check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P3139 and engine control unit are in charge of monitoring a bunch of different seat rear vertical motor position out of range, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Chrysler 300 P3139 OBD2 Code

A common cause of code P3139 is the failure of Seat Rear Vertical Motor Position Out of Range, but there are several other possible causes as well, such as ;

1Camshaft Position Sensor circuit poor electrical connection
Camshaft Position Sensor harness is open or shorted
1Camshaft Position Sensor circuit poor electrical connection
Improper ignition timing

P3139 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

P3139 Chrysler 300 OBD Code

P3139 Chrysler 300 Error Code Repair Process :

Common Causes of Chrysler 300 P3139 OBD2 Code

P3139 code for other Chrysler cars