P3337 Toyota Proace OBD Code

OBD/2 P3337 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC P3337 as an indication of a hard fault.

Circuit High Input codes like P3337 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

P3337 Toyota Proace Error Code Repair Process :

The scent may P3337 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such P3337, so if the inside of your car aux heater overheat sensor circuit open as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Common Causes of Toyota Proace P3337 OBD2 Code

A common cause of code P3337 is the failure of Aux Heater Overheat Sensor Circuit Open, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty starter motor
Erratic camshaft position due to low oil pressure
Fuel pressure

P3337 is a kind of Powertrain Trouble Code

Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P3337 Toyota Proace OBD Code

P3337 Toyota Proace Error Code Repair Process :

Common Causes of Toyota Proace P3337 OBD2 Code

P3337 code for other Toyota cars