P3535 Alpine Berlinette OBD Code

OBD/2 P3535 error code description and symptoms.

Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM). If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

P3535 Alpine Berlinette Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine P3535 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If speed wheel sensor rf input short circuit to ground so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the speed wheel sensor rf input short circuit to ground.

Difficulty Level (Soso)

Repair Time (30 Min.)

Cost Prediction : $ 75-90

Common Causes of Alpine Berlinette P3535 OBD2 Code

A common cause of code P3535 is the failure of Speed Wheel Sensor RF Input Short Circuit To Ground, but there are several other possible causes as well, such as ;

• Damaged camshaft position (CMP) sensor
• Faulty front heated oxygen sensor
• Engine Control Module (ECM)
• Missing or loose fuel cap

P3535 is a kind of Powertrain Trouble Code Powertrain of a modern automobile, comprising engine (with exhaust system), transmission, drive shaft, suspension and the wheels. In a motor vehicle, the term powertrain or powerplant describes the main components that generate power and deliver it to the road surface, water, or air.

P3535 code for other Alpine cars

You can view according P3535 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• P3535 Alpine A106
• P3535 Alpine A108
• P3535 Alpine A108-904
• P3535 Alpine A110
• P3535 Alpine A310
• P3535 Alpine A442
• P3535 Alpine A610
• P3535 Alpine Cabriolet
• P3535 Alpine Coupe
• P3535 Alpine V6

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved