U0178 Proto Spirra OBD Code

OBD/2 U0178 error code description and symptoms.

HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U0178 Proto Spirra Error Code Repair Process :

If your scp (j1850) lack of acknowledgment for primary id check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U0178 and engine control unit are in charge of monitoring a bunch of different scp (j1850) lack of acknowledgment for primary id, and if they get a reading that's a little out of whack, up pops the check engine light.

Difficulty Level (Expert)

Repair Time (35 Min.)

Cost Prediction : $ 40-75

Common Causes of Proto Spirra U0178 OBD2 Code

A common cause of code U0178 is the failure of SCP (J1850) Lack of Acknowledgment for Primary Id, but there are several other possible causes as well, such as ;

• Exhaust tube
• Faulty Mass Air Flow (MAF) sensor
• Continuous oil flow to the VCT piston chamber
• Fuel injectors may be faulty

U0178 is a kind of Network Trouble Code U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U0178 code for other Proto cars

You can view according U0178 DTC for your car model. We selected several models to see obd2 solutions click and view it.

• U0178 Proton 300
• U0178 Proton 400
• U0178 Proton Arena
• U0178 Proton Gen
• U0178 Proton Gen2
• U0178 Proton Impian
• U0178 Proton Inspira
• U0178 Proton Juara
• U0178 Proton Perdana
• U0178 Proton Persona
• U0178 Proton Preve
• U0178 Proton Putra
• U0178 Proton Saga Flx
• U0178 Proton Saloon
• U0178 Proton Satria
• U0178 Proton Savvy
• U0178 Proton Tiara
• U0178 Proton Waja
• U0178 Proton Wira

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved