Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.
To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.
Difficulty Level (Soso)
|
Repair Time (50 Min.)
|
| Cost Prediction : $ 20-50 |
If your vehicle failed a U0411 test and the U0411 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses camshaft position sensor circuit intermittent a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look camshaft position sensor circuit intermittent: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.
|
U0411 is a kind of Network Trouble Code
U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason. |
You can view according U0411 DTC for your car model. We selected several models to see obd2 solutions click and view it.
| +U0411 Hummer H3 | +U0411 Suzuki Vitara Iv | +U0411 Opel Astra J | +U0411 Healey Sportsmobile | +U0411 Autobianchi A112 |
Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.
Copyright 2017 © All rights reserved