U0493 Abarth 1000 OBD Code

OBD/2 U0493 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

Gear changes are accomplished by a command from the TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.

U0493 Abarth 1000 Error Code Repair Process :

The rule of U0493 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of vehicle speed sensor malfunction. Likewise, overriding the OBD U0493 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Abarth 1000 U0493 OBD2 Code

A common cause of code U0493 is the failure of Vehicle Speed Sensor Malfunction, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
EVAP system hose leaking
Faulty select solenoid
Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection

U0493 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U0493 Abarth 1000 OBD Code

U0493 Abarth 1000 Error Code Repair Process :

Common Causes of Abarth 1000 U0493 OBD2 Code

U0493 code for other Abarth cars