U2013 Plymouth Cambridge OBD Code

OBD/2 U2013 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U2013, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code U2013 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

U2013 Plymouth Cambridge Error Code Repair Process :

If your u2013 compass module is not responding check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2013 and engine control unit are in charge of monitoring a bunch of different u2013 compass module is not responding, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Plymouth Cambridge U2013 OBD2 Code

A common cause of code U2013 is the failure of U2013 Compass Module is not Responding, but there are several other possible causes as well, such as ;

Damaged VCT phaser
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty Intake Valve Timing Control Solenoid Valve
Faulty Camshaft Position Sensor

U2013 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2013 Plymouth Cambridge OBD Code

U2013 Plymouth Cambridge Error Code Repair Process :

Common Causes of Plymouth Cambridge U2013 OBD2 Code

U2013 code for other Plymouth cars