U20E1 Toyota 700 OBD Code

OBD/2 U20E1 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U20E1 Toyota 700 Error Code Repair Process :

If your mirror driver vertical feedback potentiometer circuit short to ground check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U20E1 and engine control unit are in charge of monitoring a bunch of different mirror driver vertical feedback potentiometer circuit short to ground, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Toyota 700 U20E1 OBD2 Code

A common cause of code U20E1 is the failure of Mirror Driver Vertical Feedback Potentiometer Circuit Short to Ground, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty Mass Air Flow (MAF) sensor
Damaged VCT phaser
Faulty Intake Valve Timing Control Solenoid Valve

U20E1 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U20E1 Toyota 700 OBD Code

U20E1 Toyota 700 Error Code Repair Process :

Common Causes of Toyota 700 U20E1 OBD2 Code

U20E1 code for other Toyota cars