U2265 Fiat Tempra OBD Code

OBD/2 U2265 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.

U2265 Fiat Tempra Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2265 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If wheel speed sensor rf tone ring tooth missing fault so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the wheel speed sensor rf tone ring tooth missing fault.

Common Causes of Fiat Tempra U2265 OBD2 Code

A common cause of code U2265 is the failure of Wheel Speed Sensor RF Tone Ring Tooth Missing Fault, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty TCM or TCM programming
Fuel injectors harness is open or shorted
Failures of clutch motion/travel sensors.

U2265 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U2265 Fiat Tempra OBD Code

U2265 Fiat Tempra Error Code Repair Process :

Common Causes of Fiat Tempra U2265 OBD2 Code

U2265 code for other Fiat cars