U2469 Trouble Code

OBD/2 U2469 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

Difficulty Level (Soso)
Level
Repair Time (30 Min.)
Time
Cost Prediction : $ 70-220

U2469 Error Code Repair Process :

If your vehicle failed a U2469 test and the U2469 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses right rear center sensor circuit fault a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look right rear center sensor circuit fault: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Wrench Tool U2469 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Common Causes of U2469

A common cause of code U2469 is the failure of Right Rear Center Sensor Circuit Fault, but there are several other possible causes as well, such as ;

U2469 code for all cars

You can view according U2469 DTC for your car model. We selected several models to see obd2 solutions click and view it.

+U2469 Mitsubishi Space Wagon +U2469 Daihatsu Gran +U2469 Squire Tt +U2469 Mazda 6 +U2469 Kia Sorento Iii

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved