U2767 Jensen Interceptor OBD Code

OBD/2 U2767 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Circuit High Input codes like U2767 are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that 'leak' current into a particular system from other, unrelated systems that work on higher voltages. Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a 'high input' code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.

U2767 Jensen Interceptor Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U2767 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If scp (j1850) invalid or missing data for external access (doors) so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the scp (j1850) invalid or missing data for external access (doors).

Common Causes of Jensen Interceptor U2767 OBD2 Code

A common cause of code U2767 is the failure of SCP (J1850) Invalid or Missing Data for External Access (Doors), but there are several other possible causes as well, such as ;

Damaged VCT phaser
Exhaust gas leaks
Faulty select solenoid
Faulty Mass Air Flow (MAF) sensor

U2767 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U2767 Jensen Interceptor OBD Code

U2767 Jensen Interceptor Error Code Repair Process :

Common Causes of Jensen Interceptor U2767 OBD2 Code

U2767 code for other Jensen cars