U3019 Mitsubishi 380 OBD Code

OBD/2 U3019 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

On some transmissions, such as automated manual transmissions or automatic transmissions with manual mode, the GSP switch lets the TCM know whether or not the driver has selected automatic or manual function. On manual transmissions, the GSP switch informs the TCM which gear the driver is selecting, and may function as a neutral safety switch, depending on system design. The TCM also uses the gate select position switch to monitor transmission operation. For example, if the driver selects manual mode and selects 3rd gear on an automatic transmission, the TCM may monitor speed sensors to detect clutch and brake slippage.

U3019 Mitsubishi 380 Error Code Repair Process :

If your knock sensor 2 circuit intermittent (bank 2) check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3019 and engine control unit are in charge of monitoring a bunch of different knock sensor 2 circuit intermittent (bank 2), and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Mitsubishi 380 U3019 OBD2 Code

A common cause of code U3019 is the failure of Knock Sensor 2 Circuit Intermittent (Bank 2), but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Failures of clutch motion/travel sensors.
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
Faulty spark plug (s)

U3019 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3019 Mitsubishi 380 OBD Code

U3019 Mitsubishi 380 Error Code Repair Process :

Common Causes of Mitsubishi 380 U3019 OBD2 Code

U3019 code for other Mitsubishi cars