U3109 Rover Streetwise OBD Code

OBD/2 U3109 error code description and symptoms.

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

Regardless of the design though, the purpose of all clutch actuating systems is to improve the driving experience by removing the need for manual clutch operation by the driver. Computer-controlled clutch actuating systems work particularly well in dual clutch systems where one clutch controls gear changes of even-numbered gear ratios, and a second clutch that controls gear changes of odd-numbered ratios.

U3109 Rover Streetwise Error Code Repair Process :

The rule of U3109 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of evaporative emission control system pressure sensor high input. Likewise, overriding the OBD U3109 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Difficulty Level (Easy)
Level
Repair Time (45 Min.)
Time
Cost Prediction : $ 80-170

Common Causes of Rover Streetwise U3109 OBD2 Code

A common cause of code U3109 is the failure of Evaporative Emission Control System Pressure Sensor High Input, but there are several other possible causes as well, such as ;
Wrench Tool U3109 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U3109 code for other Rover cars

You can view according U3109 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved