U3607 Honda Argento OBD Code

OBD/2 U3607 error code description and symptoms.

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

In most cases, the TCM is integrated into a single housing with the PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately. In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.

U3607 Honda Argento Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U3607 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If low fan control primary circuit malfunction so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the low fan control primary circuit malfunction.

Common Causes of Honda Argento U3607 OBD2 Code

A common cause of code U3607 is the failure of Low Fan Control Primary Circuit Malfunction, but there are several other possible causes as well, such as ;

Camshaft Position Sensor harness is open or shorted
Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
Faulty oil control valve (OCV)
Loss of ground.

U3607 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3607 Honda Argento OBD Code

U3607 Honda Argento Error Code Repair Process :

Common Causes of Honda Argento U3607 OBD2 Code

U3607 code for other Honda cars