U3714 Jaguar 420 OBD Code

OBD/2 U3714 error code description and symptoms.

EGR Flow Insufficient Detected The EGR system is monitored during steady state driving conditions while the EGR is commanded on.
The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum. Vacuum supply EGR valve stuck closed EGR valve leaks vacuum EGR flow path restricted EGRVR circuit shorted to PWR VREF open to D.P.F. EGR sensor D.P.F. EGR sensor downstream hose off or plugged EGRVR circuit open to PCM VPWR open to EGRVR solenoid D.P.F. EGR sensor hoses both off D.P.F. EGR sensor hoses reversed Damaged EGR orifice tube Damaged EGRVR solenoid Damaged PCM Perform KOER self-test and look for DTC U3714 as an indication of a hard fault.

One example of this would be when an automatic vehicle in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.

U3714 Jaguar 420 Error Code Repair Process :

If your control module long term memory performance/ immobilizer code words do not match check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U3714 and engine control unit are in charge of monitoring a bunch of different control module long term memory performance/ immobilizer code words do not match, and if they get a reading that's a little out of whack, up pops the check engine light.

Common Causes of Jaguar 420 U3714 OBD2 Code

A common cause of code U3714 is the failure of Control Module Long Term Memory Performance/ Immobilizer Code Words Do Not Match, but there are several other possible causes as well, such as ;

Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
Faulty Mass Air Flow (MAF) sensor
Faulty ignition coil (s)
Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

U3714 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3714 Jaguar 420 OBD Code

U3714 Jaguar 420 Error Code Repair Process :

Common Causes of Jaguar 420 U3714 OBD2 Code

U3714 code for other Jaguar cars