U3894 Jaguar C-type OBD Code

OBD/2 U3894 error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U3894, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code U3894 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

U3894 Jaguar C-type Error Code Repair Process :

The rule of U3894 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of transmission transfer case differential lock-up feedback switch circuit failure. Likewise, overriding the OBD U3894 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Common Causes of Jaguar C-type U3894 OBD2 Code

A common cause of code U3894 is the failure of Transmission Transfer Case Differential Lock-Up Feedback Switch Circuit Failure, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
EVAP canister or fuel tank leaks
Improper ignition timing
Incorrect fuel filler cap used

U3894 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U3894 Jaguar C-type OBD Code

U3894 Jaguar C-type Error Code Repair Process :

Common Causes of Jaguar C-type U3894 OBD2 Code

U3894 code for other Jaguar cars