U3403 Volvo 760 OBD Code

OBD/2 U3403 error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source. Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

U3403 Volvo 760 Error Code Repair Process :

The rule of U3403 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of intercooler pump driver fault. Likewise, overriding the OBD U3403 error in system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Difficulty Level (Easy)
Level
Repair Time (20 Min.)
Time
Cost Prediction : $ 60-110

Common Causes of Volvo 760 U3403 OBD2 Code

A common cause of code U3403 is the failure of Intercooler Pump Driver Fault, but there are several other possible causes as well, such as ;
Wrench Tool U3403 is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U3403 code for other Volvo cars

You can view according U3403 DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved