U054C Holden Gts OBD Code

OBD/2 U054C error code description and symptoms.

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions. However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.

U054C Holden Gts Error Code Repair Process :

When you turn on the ignition, the Service Engine Soon or Check Engine U054C light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If transmission fluid temperature sensor circuit range/performance so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the transmission fluid temperature sensor circuit range/performance.

Common Causes of Holden Gts U054C OBD2 Code

A common cause of code U054C is the failure of Transmission Fluid Temperature Sensor Circuit Range/Performance, but there are several other possible causes as well, such as ;

Engine Control Module (ECM)
Faulty front heated oxygen sensor
Foreign matter caught in fuel filler cap
Faulty Intake Valve Timing Control Solenoid Valve

U054C is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

U054C Holden Gts OBD Code

U054C Holden Gts Error Code Repair Process :

Common Causes of Holden Gts U054C OBD2 Code

U054C code for other Holden cars