U054C Holden Hj OBD Code

OBD/2 U054C error code description and symptoms.

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U054C, so consult the manual to locate the brake fluid reservoir. Bear in mind that a low fluid level can set code U054C on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

U054C Holden Hj Error Code Repair Process :

For transmission fluid temperature sensor circuit range/performance check engine light is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U054C error code diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks transmission fluid temperature sensor circuit range/performance with your car's computers to find out exactly what's prompting the light to turn on.

Difficulty Level (Soso)
Level
Repair Time (50 Min.)
Time
Cost Prediction : $ 70-120

Common Causes of Holden Hj U054C OBD2 Code

A common cause of code U054C is the failure of Transmission Fluid Temperature Sensor Circuit Range/Performance, but there are several other possible causes as well, such as ;
Wrench Tool U054C is a kind of Network Trouble Code

U-code indicates that engine communication errors and shows lost communication with engine parts.U-Codes are fairly straight forward, given all of the articles and technical publications that have been written regarding these problematic codes. In most cases, it just comes down to identifying the module that isn't communicating with the other modules on the CAN bus line for whatever reason.

U054C code for other Holden cars

You can view according U054C DTC for your car model. We selected several models to see obd2 solutions click and view it.

Engine OBD 2 Codes website is a freeware resource center for engine trouble codes.

About Us | Contact | Privacy

Copyright 2017 © All rights reserved